Brake assembly 30-63A
The brake assembly 30-63A by Cleveland is designed as a floating brake caliper and can be mounted to 6′′ disk brake wheels of the series Classic. The simple but robust design of the brake assembly ensures a long service time and easy maintenance with good deceleration values.
| P/N | Description | Hydraulic fluid |
Application | Brake torque Nm |
Connecting thread |
Weight g |
Brake disk thickness mm |
| 076810 | 30-63A | Mineral Fluid | 6″ SB Classic | 450 | 1/8″ NPT | 840 | 6 |
| 076820 | 30-63A | DOT4 | 6″ SB Classic | 450 | 1/8″ NPT | 840 | 6 |
The anchor plate for the mounting to the landing gear is part of the scope of delivery. Customized anchor plates can be offered according to your requirements.
Spare parts brake assembly 30-63A
| P/N | Description | Hydraulic fluid |
Remarks | Number |
| 076829 | Piston housing | N/A | 1 | |
| 076825 | Piston | N/A | 2 | |
| 076834 | O-ring | Mineral Fluid | 3 | |
| 076835 | O-ring | DOT4 | 3 | |
| 075870 | Anchor bolt | N/A | 5″ Cleveland, 5″/ 6″ SBP Penta |
4 |
| 075869 | Anchor bolt | N/A | 4″ SRT Tria, 4″ SB Classic, 5″ SB Classic |
4 |
| 075881 | Nut anchor bolt | N/A | 5 | |
| 075882 | Washer anchor bolt | N/A | 6 | |
| 076873 | Housing bolt | N/A | 7 | |
| 075882 | Washer housing bolt | N/A | 8 | |
| 075832 | Bleeder valve complete | N/A | also Stahlbus bleeder valve possible, quod vide | 9 |
| 076872 | Pressure plate with brake lining | N/A | 10-12 | |
| 076862 | Brake lining | N/A | 11 | |
| 075861 | Rivet brake lining | N/A | 12 | |
| 076871 | Back plate with brake lining | N/A | 11-13 | |
| 076865 | Service kit for brake lining replacement | N/A | 2 x brake lining, 4 x rivet |
11, 12 |
| 076891 | Anchor plate for brake assembly 30-63A | – |
Brake lining wear limit:
The minimum replacement thickness for brake linings is 2.5 mm. The total thickness of brake linings at no point must be less than 2.5 mm.
Installation note:
After mounting the brake assembly, tighten the hexagonal bolt with a tightening torque of 6.8 Nm (60 in-lb) and secure with locking wire 0.8 mm Spec. MS-20995.
For the correlation of the spare parts kindly refer to the shematic drawing of the brake assembly 30-9
